TNT TL-HOP 60° Precision Lightweight Rubber Bucking Set for AEG

• for Marui AEG Hop Systems

Based on H.L.R. rubber, unlike most "rectangular" pressure zone designs, we followed the design of the arcuate pressure zone "from front to back, from left to right", which eases the angle of stress and release. . It is beneficial to improve ballistic stability and is suitable for low muzzle velocity pistols or competition short guns.

Recommended equipment: 0.12g～0.32g BBs

【About muzzle speed】

TL-HOP BUCKING is designed for muzzle speed AEG, GBB pistols, competitive short guns, or rifles with MARUI AEG specification. The recommended muzzle speed is about 0.8J~1.5J. For high muzzle speed requirement, it is recommended to choose H.L.R. rubber.

【Corresponding weight of bbs】

TL-HOP BUCKING is specially designed for light bbs. Its main purpose is to "increase the stability of light bbs". The recommended weight is 0.12g~0.32g bbs.

【Degree selection】

Under normal conditions, it is recommended to use 60 degrees rubber,50 degrees rubber generally recommended for cold areas.

【Specifications】

TL-HOP BUCKING has GBB and AEG specifications. The GBB specification is a regular version and can be assembled with precision inner barrels and hop-up chambers with the same specification as the original MARUI (general specification). With the same specification, GBB rifles can also be equipped with this rubber.

※The above are all are general recommendations for a general setup. Configurations and fine-tuning may be required as according to the setup.